Stainless steel pipe is strong, light weight, stainless steel bright annealed tube and usually easy to use. However, when you need to flare the tube, you need the right equipment. Flaring to expand the tube in order to increase its diameter to the end. Flaring tools and pipe clamp bar can be purchased or leased from a pipe supply store. Burning tool using the cone-shaped pieces of metal into the tube and a round, torch-shaped clamp around the pipe end. When the cone screw tube to force the steel to take the shape of the torch.

1 Insert the tubing burning tool clamp bar.

2 inserted into the bar and tighten the vice, vice clamp securely.

Three hacksaw to cut the length of the stainless steel tube, close the clamp bar as far as possible. Strokes with light pressure, to make sure you do not bend the tube, cut at the same time. As you approach the year end, otherwise you may damage the tube with minimal pressure. The best results will come from a blade 32 teeth per inch or more.

4 files close any hanging steel left after you cut. Then gently file down the tube until it is smooth square meters. Filing tube, until it and the clamp lever flush is the best way to ensure that the cut is square.

5 Remove the clamp rod tube from the vice.

6 files, you cut the outer edges,  heat exchanger tubes remove burrs, to keep the file in 30-degree angle pipe and slowly rotating your file.

Cutting edge of the corner of 7 files are placed in the tube file. Slowly rotating the tube file.

8 end into the burning tool, rinse the end of the speaker hole.

Held on the 9th block burning tool head, according to the manufacturer's instructions. Make sure that the burning of the nose cone has been concentrated.

10 to Cone tighten. The cone will force the shape of the steel tube speaker holes.

11 Stainless steel pipes deleted in order to ensure a smooth and comprehensive torch from burning tools, pipe and check pipe.